Adblue-Emulator für Mercedes MP3 All Trucks Euro 5

Verkabelter Adblue-Emulator für Mercedes MP3 All Trucks Euro 5 (2007-2013). Komplette SCR- & NOx-Deaktivierung. Einbau in 10-15 Minuten, ohne Programmierung.

1–3: €285 · 4–5: €240 · 6+: €200

  • Kompatible Modelle: Mercedes MP3 ALL TRUCKS
  • Baujahre: 2007–2013
  • Emulatortyp: Hard-wired
  • Marke: Can Logic
  • Garantie: 2 years

Dieses Gerät ersetzt

  • SCR / ECU-Steuergerät
  • Adblue-Pumpenmodul
  • Drucksensor
  • Adblue-Füllstandsensor
  • Temperatursensor
  • NOx vor Katalysator
  • NOx nach Katalysator

Beschreibung

Gewicht: 0.66kg

Marke: Can Logic

Emulator-Typ: Verkabelt

Geld-zurück-Garantie: 14 days

2 Jahre Garantie

Kostenloser technischer Online-Support für unsere Kunden

Professioneller Adblue-Emulator, Anleitung im Lieferumfang

Hergestellt aus hochwertigsten Automotive-Komponenten

Geräteinformationen

Produktcode: ME-MP3-E5-W

Produkttyp: Adblue-Emulator

Motortyp: MERCEDES

Kompatibles Steuergerät: TEMIC

MB Serie: 3 series / MP3

Abgasnorm: EURO5

Für LKW Baujahr 2007 - 2013

Kompatible Modelle: ACTROS, ATEGO, AXOR, ECONIC

Installation

Step 1: Wiring the emulator

Turn off the ignition. Remove the 4 screws that hold the plastic dashboard, carefully remove the covers to gain access to the wire harnesses and fuses.

Step 2: Wiring

Locate the OBD plug of the vehicle. The unit has 4 wires that need to be connected to the vehicle's OBD harness (refer to the diagram below, front perspective).

Step 3: Adblue and Air pressure sensors

Connect the blue wire from the emulator to the Adblue pressure sensor, and the gray wire to the Air sensor. To accomplish this, you will need to route wires from the OBD connector to the engine compartment beneath the cab, as the pressure sensors are situated on the engine.

After that, cut the wire from PIN1 of the sensor and connect the wire from the emulator to it.

Step 4: Disable SCR sistem

Locate the F1 fuse and disable/remove it.

Step 5: Disable NOx

Find the NOx sensor wire harness and cut the red- brown wire within it. Make sure to isolate it afterwards.

Step 6: Check Adblue levels

Turn on the ignition of the vehicle and check the Adblue levels. If the gauge is at around 75 or 90%, then the emulator is connected properly.

Once checked, place the emulator in a safe spot and fix it with a strap to avoid it rattling around. When done, the dashboard cover can be reattached.

Ähnliche Produkte