Emulador de Adblue para Mercedes MP3 All Trucks Euro 5

Adblue emulador con cable para Mercedes MP3 All Trucks Euro 5 (2007-2013). Anulación total de SCR y NOx. Se instala en 10-15 minutos, sin programación.

1–3: €285 · 4–5: €240 · 6+: €200

  • Modelos compatibles: Mercedes MP3 ALL TRUCKS
  • Años de fabricación: 2007–2013
  • Tipo de emulador: Hard-wired
  • Marca: Can Logic
  • Garantía: 2 years

Este dispositivo reemplaza

  • Unidad de control SCR / ECU
  • Módulo de bomba Adblue
  • Sensor de presión
  • Sensor de nivel Adblue
  • Sensor de temperatura
  • NOx antes del catalizador
  • NOx después del catalizador

Descripción

Peso: 0.66kg

Marca: Can Logic

Tipo de emulador: Cableado

Garantía de devolución: 14 days

2 años de garantía

Soporte técnico en línea gratuito para nuestros clientes

Emulador Adblue profesional, instrucciones incluidas

Fabricado con componentes de calidad automotriz superior

Información del dispositivo

Código de producto: ME-MP3-E5-W

Tipo de producto: Emulador Adblue

Tipo de motor: MERCEDES

ECU compatible: TEMIC

MB Serie: 3 series / MP3

Norma de emisiones: EURO5

Para camiones fabricados 2007 - 2013

Modelos compatibles: ACTROS, ATEGO, AXOR, ECONIC

Instalación

Step 1: Wiring the emulator

Turn off the ignition. Remove the 4 screws that hold the plastic dashboard, carefully remove the covers to gain access to the wire harnesses and fuses.

Step 2: Wiring

Locate the OBD plug of the vehicle. The unit has 4 wires that need to be connected to the vehicle's OBD harness (refer to the diagram below, front perspective).

Step 3: Adblue and Air pressure sensors

Connect the blue wire from the emulator to the Adblue pressure sensor, and the gray wire to the Air sensor. To accomplish this, you will need to route wires from the OBD connector to the engine compartment beneath the cab, as the pressure sensors are situated on the engine.

After that, cut the wire from PIN1 of the sensor and connect the wire from the emulator to it.

Step 4: Disable SCR sistem

Locate the F1 fuse and disable/remove it.

Step 5: Disable NOx

Find the NOx sensor wire harness and cut the red- brown wire within it. Make sure to isolate it afterwards.

Step 6: Check Adblue levels

Turn on the ignition of the vehicle and check the Adblue levels. If the gauge is at around 75 or 90%, then the emulator is connected properly.

Once checked, place the emulator in a safe spot and fix it with a strap to avoid it rattling around. When done, the dashboard cover can be reattached.

Productos relacionados