Émulateur Adblue pour Mercedes MP3 All Trucks Euro 5

Adblue émulateur filaire pour Mercedes MP3 All Trucks Euro 5 (2007-2013). Suppression totale SCR et NOx. S'installe en 10-15 minutes, sans programmation.

1–3: €285 · 4–5: €240 · 6+: €200

  • Modèles compatibles: Mercedes MP3 ALL TRUCKS
  • Plage d'années: 2007–2013
  • Type d'émulateur: Hard-wired
  • Marque: Can Logic
  • Garantie: 2 years

Cet appareil remplace

  • Unité de commande SCR / ECU
  • Module de pompe Adblue
  • Capteur de pression
  • Capteur de niveau Adblue
  • Capteur de température
  • NOx avant catalyseur
  • NOx après catalyseur

Description

Poids: 0.66kg

Marque: Can Logic

Type d'émulateur: Câblé

Garantie satisfait ou remboursé: 14 days

Garantie 2 ans

Support technique en ligne gratuit pour nos clients

Émulateur Adblue professionnel, notice fournie

Fabriqué avec des composants automobiles de la plus haute qualité

Informations sur l'appareil

Code produit: ME-MP3-E5-W

Type de produit: Émulateur Adblue

Type de moteur: MERCEDES

ECU compatible: TEMIC

MB Série: 3 series / MP3

Norme d'émissions: EURO5

Pour camions construits 2007 - 2013

Modèles compatibles: ACTROS, ATEGO, AXOR, ECONIC

Installation

Step 1: Wiring the emulator

Turn off the ignition. Remove the 4 screws that hold the plastic dashboard, carefully remove the covers to gain access to the wire harnesses and fuses.

Step 2: Wiring

Locate the OBD plug of the vehicle. The unit has 4 wires that need to be connected to the vehicle's OBD harness (refer to the diagram below, front perspective).

Step 3: Adblue and Air pressure sensors

Connect the blue wire from the emulator to the Adblue pressure sensor, and the gray wire to the Air sensor. To accomplish this, you will need to route wires from the OBD connector to the engine compartment beneath the cab, as the pressure sensors are situated on the engine.

After that, cut the wire from PIN1 of the sensor and connect the wire from the emulator to it.

Step 4: Disable SCR sistem

Locate the F1 fuse and disable/remove it.

Step 5: Disable NOx

Find the NOx sensor wire harness and cut the red- brown wire within it. Make sure to isolate it afterwards.

Step 6: Check Adblue levels

Turn on the ignition of the vehicle and check the Adblue levels. If the gauge is at around 75 or 90%, then the emulator is connected properly.

Once checked, place the emulator in a safe spot and fix it with a strap to avoid it rattling around. When done, the dashboard cover can be reattached.

Produits associés