Émulateur Adblue pour Renault T, K, C Euro 6

Adblue émulateur filaire pour Renault T, K, C Euro 6 (2014-2021). Suppression totale SCR, NOx et DPF. S'installe en 10-15 minutes, sans programmation.

1–3: €295 · 4–5: €235 · 6+: €175

  • Modèles compatibles: Renault T, K, C
  • Plage d'années: 2014–2021
  • Type d'émulateur: Hard-wired
  • Marque: Can Logic
  • Garantie: 2 years

Description

Poids: 0.66kg

Marque: Can Logic

Type d'émulateur: Câblé

Garantie satisfait ou remboursé: 14 days

Garantie 2 ans

Support technique en ligne gratuit pour nos clients

Émulateur Adblue professionnel, notice fournie

Fabriqué avec des composants automobiles de la plus haute qualité

Informations sur l'appareil

Code produit: ME-RT-E6-W

Type de produit: Émulateur Adblue

Type de moteur: RENAULT

ECU compatible: EMS

VOLVO Série: 4 series

Norme d'émissions: EURO 6

Pour camions construits 2014 - 2021

Modèles compatibles: T, K, C

Installation

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug)

Power connections:

BROWN wire from emulator connect to - PIN 58 (-Negative)

RED wire from emulator connect to- PIN 60 (+ Positive/power)

CAN LINE Connections:

CAN 1 - Cut wires PIN1 and PIN5 and connect the emulator to the wires going toward the truck, not to the ends that goes into the plug.

WHITE wire from emulator connect to PIN1

BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

GREEN wire from emulator connect to PIN10

YELLOW wire from emulator connect to PIN14

Step three:

Please disconnect NOx sensor. To do this please cut wire from PIN 49 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

Produits associés