Emulatore Adblue per Mercedes MP3 All Trucks Euro 5

Emulatore Adblue cablato per Mercedes MP3 All Trucks Euro 5 (2007-2013). Esclusione completa di SCR e NOx. Si installa in 10-15 minuti, senza programmazione.

1–3: €285 · 4–5: €240 · 6+: €200

  • Modelli compatibili: Mercedes MP3 ALL TRUCKS
  • Anni di produzione: 2007–2013
  • Tipo di emulatore: Hard-wired
  • Marca: Can Logic
  • Garanzia: 2 years

Questo dispositivo sostituisce

  • Unità di controllo SCR / ECU
  • Modulo pompa Adblue
  • Sensore di pressione
  • Sensore livello Adblue
  • Sensore di temperatura
  • NOx pre-catalizzatore
  • NOx post-catalizzatore

Descrizione

Peso: 0.66kg

Marca: Can Logic

Tipo di emulatore: Cablato

Garanzia rimborso: 14 days

2 anni di garanzia

Supporto tecnico online gratuito per i nostri clienti

Emulatore Adblue professionale, istruzioni incluse

Realizzato con componenti automotive di altissima qualità

Informazioni dispositivo

Codice prodotto: ME-MP3-E5-W

Tipo di prodotto: Emulatore Adblue

Tipo di motore: MERCEDES

ECU compatibile: TEMIC

MB Serie: 3 series / MP3

Norma emissioni: EURO5

Per camion costruiti 2007 - 2013

Modelli compatibili: ACTROS, ATEGO, AXOR, ECONIC

Installazione

Step 1: Wiring the emulator

Turn off the ignition. Remove the 4 screws that hold the plastic dashboard, carefully remove the covers to gain access to the wire harnesses and fuses.

Step 2: Wiring

Locate the OBD plug of the vehicle. The unit has 4 wires that need to be connected to the vehicle's OBD harness (refer to the diagram below, front perspective).

Step 3: Adblue and Air pressure sensors

Connect the blue wire from the emulator to the Adblue pressure sensor, and the gray wire to the Air sensor. To accomplish this, you will need to route wires from the OBD connector to the engine compartment beneath the cab, as the pressure sensors are situated on the engine.

After that, cut the wire from PIN1 of the sensor and connect the wire from the emulator to it.

Step 4: Disable SCR sistem

Locate the F1 fuse and disable/remove it.

Step 5: Disable NOx

Find the NOx sensor wire harness and cut the red- brown wire within it. Make sure to isolate it afterwards.

Step 6: Check Adblue levels

Turn on the ignition of the vehicle and check the Adblue levels. If the gauge is at around 75 or 90%, then the emulator is connected properly.

Once checked, place the emulator in a safe spot and fix it with a strap to avoid it rattling around. When done, the dashboard cover can be reattached.

Prodotti correlati