Emulatore Adblue per Volvo FH5, FM5, FMX5 Euro 6

Emulatore Adblue (on/off) per Volvo FH5, FM5, FMX5 Euro 6 (2022-2024). Esclusione completa di SCR, NOx e DPF. Si installa in 10-15 minuti, senza programmazione.

1–3: €320 · 4–5: €260 · 6+: €200

  • Modelli compatibili: Volvo FH5, FM5, FMX5
  • Anni di produzione: 2022–2024
  • Tipo di emulatore: On/Off Switch
  • Marca: Can Logic
  • Garanzia: 2 years

Questo dispositivo sostituisce

  • Unità di controllo SCR / ECU
  • Sistema di scarico DPF
  • Modulo pompa Adblue
  • Sensore di pressione
  • Sensore livello Adblue
  • Sensore di temperatura
  • NOx pre-catalizzatore
  • NOx post-catalizzatore

Descrizione

Peso: 0.03kg

Marca: Can Logic

Tipo di emulatore: On/Off Switch

Garanzia rimborso: 14 days

2 anni di garanzia

Supporto tecnico online gratuito per i nostri clienti

Emulatore Adblue professionale, istruzioni incluse

Realizzato con componenti automotive di altissima qualità

Informazioni dispositivo

Codice prodotto: ME-FH5-E6-ON

Tipo di prodotto: Emulatore Adblue

Tipo di motore: VOLVO

ECU compatibile: EMS

VOLVO Serie: 5 series

Norma emissioni: EURO 6

Per camion costruiti 2022 - 2025

Modelli compatibili: All Trucks

Installazione

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Prodotti correlati