Adblue emuliatorius, skirtas Mercedes MP3 All Trucks Euro 5

Laidinis Adblue emuliatorius Mercedes MP3 All Trucks Euro 5 vilkikams (2007-2013). Visiškas SCR ir NOx išjungimas. Montavimas per 10-15 min, be programavimo.

1–3: €285 · 4–5: €240 · 6+: €200

  • Suderinami modeliai: Mercedes MP3 ALL TRUCKS
  • Metų intervalas: 2007–2013
  • Emuliatoriaus tipas: Hard-wired
  • Prekės ženklas: Can Logic
  • Garantija: 2 years

Šis įrenginys pakeičia

  • SCR / ECU valdymo blokas
  • Adblue siurblio modulis
  • Slėgio jutiklis
  • Adblue lygio jutiklis
  • Temperatūros jutiklis
  • NOx prieš katalizatorių
  • NOx po katalizatoriaus

Aprašymas

Svoris: 0.66kg

Prekės ženklas: Can Logic

Emuliatoriaus tipas: Laidinis

Pinigų grąžinimo garantija: 14 days

2 metų garantija

Nemokama internetinė techninė pagalba klientams

Profesionalus Adblue emuliatorius, pridedama instrukcija

Pagaminta naudojant aukščiausios kokybės automobilių komponentus

Įrenginio informacija

Gaminio kodas: ME-MP3-E5-W

Produkto tipas: Adblue emuliatorius

Variklio tipas: MERCEDES

Suderinama ECU: TEMIC

MB Serija: 3 series / MP3

Emisijų standartas: EURO5

Sunkvežimiams, pagamintiems 2007 - 2013

Suderinami modeliai: ACTROS, ATEGO, AXOR, ECONIC

Įrengimas

Step 1: Wiring the emulator

Turn off the ignition. Remove the 4 screws that hold the plastic dashboard, carefully remove the covers to gain access to the wire harnesses and fuses.

Step 2: Wiring

Locate the OBD plug of the vehicle. The unit has 4 wires that need to be connected to the vehicle's OBD harness (refer to the diagram below, front perspective).

Step 3: Adblue and Air pressure sensors

Connect the blue wire from the emulator to the Adblue pressure sensor, and the gray wire to the Air sensor. To accomplish this, you will need to route wires from the OBD connector to the engine compartment beneath the cab, as the pressure sensors are situated on the engine.

After that, cut the wire from PIN1 of the sensor and connect the wire from the emulator to it.

Step 4: Disable SCR sistem

Locate the F1 fuse and disable/remove it.

Step 5: Disable NOx

Find the NOx sensor wire harness and cut the red- brown wire within it. Make sure to isolate it afterwards.

Step 6: Check Adblue levels

Turn on the ignition of the vehicle and check the Adblue levels. If the gauge is at around 75 or 90%, then the emulator is connected properly.

Once checked, place the emulator in a safe spot and fix it with a strap to avoid it rattling around. When done, the dashboard cover can be reattached.

Susiję produktai