Emulador de Adblue para Volvo FH5, FM5, FMX5 Euro 6

Emulador Adblue (on/off) para Volvo FH5, FM5, FMX5 Euro 6 (2022-2024). Desativação total de SCR, NOx e DPF. Instala-se em 10-15 minutos, sem programação.

1–3: €320 · 4–5: €260 · 6+: €200

  • Modelos compatíveis: Volvo FH5, FM5, FMX5
  • Intervalo de anos: 2022–2024
  • Tipo de emulador: On/Off Switch
  • Marca: Can Logic
  • Garantia: 2 years

Este dispositivo substitui

  • Unidade de controlo SCR / ECU
  • Sistema de escape DPF
  • Módulo de bomba Adblue
  • Sensor de pressão
  • Sensor de nível Adblue
  • Sensor de temperatura
  • NOx antes do catalisador
  • NOx depois do catalisador

Descrição

Peso: 0.03kg

Marca: Can Logic

Tipo de emulador: On/Off Switch

Garantia de devolução: 14 days

2 anos de garantia

Suporte técnico online gratuito para os nossos clientes

Emulador Adblue profissional, instruções incluídas

Fabricado com componentes de qualidade automotiva superior

Informações do dispositivo

Código do produto: ME-FH5-E6-ON

Tipo de produto: Emulador Adblue

Tipo de motor: VOLVO

ECU compatível: EMS

VOLVO Série: 5 series

Norma de emissões: EURO 6

Para camiões fabricados 2022 - 2025

Modelos compatíveis: All Trucks

Instalação

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Produtos relacionados