Emulator Adblue pentru Mercedes MP3 All Trucks Euro 5

Emulator Adblue cu fire pentru Mercedes MP3 All Trucks Euro 5 (2007-2013). Dezactivează complet SCR și NOx. Se montează în 10-15 minute, fără programare.

1–3: 1.525 RON · 4–5: 1.305 RON · 6+: 1.080 RON

  • Modele compatibile: Mercedes MP3 ALL TRUCKS
  • Interval de ani: 2007–2013
  • Tip de emulator: Hard-wired
  • Marca: Can Logic
  • garanție: 2 years

Acest dispozitiv înlocuiește

  • Unitate de control SCR / ECU
  • Modul pompă Adblue
  • Senzor de presiune
  • Senzor nivel Adblue
  • Senzor de temperatură
  • NOx înainte de catalizator
  • NOx după catalizator

Descriere

Greutate: 0.66kg

Marca: Can Logic

Tip emulator: Cu fir

Garanție rambursare: 14 days

Garanție 2 ani

Suport tehnic online gratuit pentru clienții noștri

Emulator Adblue profesional, instrucțiuni incluse

Fabricat din componente auto de cea mai înaltă calitate

Informații dispozitiv

Cod produs: ME-MP3-E5-W

Tip produs: Emulator Adblue

Tip motor: MERCEDES

ECU compatibil: TEMIC

MB Serie: 3 series / MP3

Standard de emisii: EURO5

Pentru camioane produse 2007 - 2013

Modele compatibile: ACTROS, ATEGO, AXOR, ECONIC

Instalare

Step 1: Wiring the emulator

Turn off the ignition. Remove the 4 screws that hold the plastic dashboard, carefully remove the covers to gain access to the wire harnesses and fuses.

Step 2: Wiring

Locate the OBD plug of the vehicle. The unit has 4 wires that need to be connected to the vehicle's OBD harness (refer to the diagram below, front perspective).

Step 3: Adblue and Air pressure sensors

Connect the blue wire from the emulator to the Adblue pressure sensor, and the gray wire to the Air sensor. To accomplish this, you will need to route wires from the OBD connector to the engine compartment beneath the cab, as the pressure sensors are situated on the engine.

After that, cut the wire from PIN1 of the sensor and connect the wire from the emulator to it.

Step 4: Disable SCR sistem

Locate the F1 fuse and disable/remove it.

Step 5: Disable NOx

Find the NOx sensor wire harness and cut the red- brown wire within it. Make sure to isolate it afterwards.

Step 6: Check Adblue levels

Turn on the ignition of the vehicle and check the Adblue levels. If the gauge is at around 75 or 90%, then the emulator is connected properly.

Once checked, place the emulator in a safe spot and fix it with a strap to avoid it rattling around. When done, the dashboard cover can be reattached.

Produse similare