Emulator Adblue pentru Volvo FH4, FM4, FMX4 Euro 6

Emulator Adblue (on/off) pentru Volvo FH4, FM4, FMX4 Euro 6 (2014-2021). Dezactivează complet SCR, NOx și DPF. Se montează în 10-15 minute, fără programare.

1–3: 1.715 RON · 4–5: 1.400 RON · 6+: 1.080 RON

  • Modele compatibile: Volvo FH4, FM4, FMX4
  • Interval de ani: 2014–2021
  • Tip de emulator: On/Off Switch
  • Marca: Can Logic
  • garanție: 2 years

Acest dispozitiv înlocuiește

  • Unitate de control SCR / ECU
  • Sistem de evacuare DPF
  • Modul pompă Adblue
  • Senzor de presiune
  • Senzor nivel Adblue
  • Senzor de temperatură
  • NOx înainte de catalizator
  • NOx după catalizator

Descriere

Greutate: 0.03kg

Marca: Can Logic

Tip emulator: On/Off Switch

Garanție rambursare: 14 days

Garanție 2 ani

Suport tehnic online gratuit pentru clienții noștri

Emulator Adblue profesional, instrucțiuni incluse

Fabricat din componente auto de cea mai înaltă calitate

Informații dispozitiv

Cod produs: ME-FH4-E6-ON

Tip produs: Emulator Adblue

Tip motor: VOLVO

ECU compatibil: EMS

VOLVO Serie: 4 series

Standard de emisii: EURO 6

Pentru camioane produse 2014 - 2021

Modele compatibile: FH4, FM4, FMX4

Instalare

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Produse similare