Adblue-emulator til Volvo FH5, FM5, FMX5 Euro 6

Adblue emulator (til/fra) til Volvo FH5, FM5, FMX5 Euro 6 (2022-2024). Fuld fjernelse af SCR, NOx & DPF. Monteres på 10-15 minutter, ingen programmering.

1–3: 2.405 kr. · 4–5: 1.960 kr. · 6+: 1.515 kr.

  • Kompatible modeller: Volvo FH5, FM5, FMX5
  • Årgange: 2022–2024
  • Emulator type: On/Off Switch
  • Mærke: Can Logic
  • Garanti: 2 years

Denne enhed erstatter

  • SCR / ECU-styreenhed
  • DPF-udstødningssystem
  • Adblue-pumpemodul
  • Tryksensor
  • Adblue-niveausensor
  • Temperatursensor
  • NOx før katalysator
  • NOx efter katalysator

Beskrivelse

Vægt: 0.03kg

Mærke: Can Logic

Emulatortype: On/Off Switch

Pengene-tilbage-garanti: 14 days

2 års garanti

Gratis online teknisk support til vores kunder

Professionel Adblue-emulator, vejledning medfølger

Fremstillet med komponenter af højeste kvalitet

Enhedsoplysninger

Produktkode: ME-FH5-E6-ON

Produkttype: Adblue-emulator

Motortype: VOLVO

Kompatibel ECU: EMS

VOLVO Serie: 5 series

Emissionsstandard: EURO 6

For lastbiler bygget 2022 - 2025

Kompatible modeller: All Trucks

Installation

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Relaterede produkter