Adblue-Emulator für Volvo FH5, FM5, FMX5 Euro 6

Adblue-Emulator (Ein/Aus) für Volvo FH5, FM5, FMX5 Euro 6 (2022-2024). Komplette SCR-, NOx- & DPF-Deaktivierung. Einbau in 10-15 Minuten, ohne Programmierung.

1–3: €320 · 4–5: €260 · 6+: €200

  • Kompatible Modelle: Volvo FH5, FM5, FMX5
  • Baujahre: 2022–2024
  • Emulatortyp: On/Off Switch
  • Marke: Can Logic
  • Garantie: 2 years

Dieses Gerät ersetzt

  • SCR / ECU-Steuergerät
  • DPF-Abgassystem
  • Adblue-Pumpenmodul
  • Drucksensor
  • Adblue-Füllstandsensor
  • Temperatursensor
  • NOx vor Katalysator
  • NOx nach Katalysator

Beschreibung

Gewicht: 0.03kg

Marke: Can Logic

Emulator-Typ: On/Off Switch

Geld-zurück-Garantie: 14 days

2 Jahre Garantie

Kostenloser technischer Online-Support für unsere Kunden

Professioneller Adblue-Emulator, Anleitung im Lieferumfang

Hergestellt aus hochwertigsten Automotive-Komponenten

Geräteinformationen

Produktcode: ME-FH5-E6-ON

Produkttyp: Adblue-Emulator

Motortyp: VOLVO

Kompatibles Steuergerät: EMS

VOLVO Serie: 5 series

Abgasnorm: EURO 6

Für LKW Baujahr 2022 - 2025

Kompatible Modelle: All Trucks

Installation

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Ähnliche Produkte