Émulateur Adblue pour Volvo FH4, FM4, FMX4 Euro 6

Adblue émulateur (on/off) pour Volvo FH4, FM4, FMX4 Euro 6 (2014-2021). Suppression totale SCR, NOx et DPF. S'installe en 10-15 minutes, sans programmation.

1–3: €320 · 4–5: €260 · 6+: €200

  • Modèles compatibles: Volvo FH4, FM4, FMX4
  • Plage d'années: 2014–2021
  • Type d'émulateur: On/Off Switch
  • Marque: Can Logic
  • Garantie: 2 years

Cet appareil remplace

  • Unité de commande SCR / ECU
  • Système d'échappement FAP
  • Module de pompe Adblue
  • Capteur de pression
  • Capteur de niveau Adblue
  • Capteur de température
  • NOx avant catalyseur
  • NOx après catalyseur

Description

Poids: 0.03kg

Marque: Can Logic

Type d'émulateur: On/Off Switch

Garantie satisfait ou remboursé: 14 days

Garantie 2 ans

Support technique en ligne gratuit pour nos clients

Émulateur Adblue professionnel, notice fournie

Fabriqué avec des composants automobiles de la plus haute qualité

Informations sur l'appareil

Code produit: ME-FH4-E6-ON

Type de produit: Émulateur Adblue

Type de moteur: VOLVO

ECU compatible: EMS

VOLVO Série: 4 series

Norme d'émissions: EURO 6

Pour camions construits 2014 - 2021

Modèles compatibles: FH4, FM4, FMX4

Installation

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Produits associés