Volvo FH4, FM4, FMX4 Euro 6용 Adblue 에뮬레이터

Volvo FH4, FM4, FMX4 Euro 6용 Adblue 에뮬레이터 (retarder) (2014-2021). SCR, NOx 및 DPF 완전 제거. 프리미엄 품질, 방수. 10-15분 만에 장착, 프로그래밍 불필요.

1–3: ₩479,650 · 4–5: ₩390,825 · 6+: ₩302,000

  • 호환 모델: Volvo FH4, FM4, FMX4
  • 연식 범위: 2014–2021
  • 에뮬레이터 유형: Hard-wired
  • 상표: Can Logic
  • 보증: 2 years

설명

무게: 0.03kg

브랜드: Can Logic

에뮬레이터 유형: 유선

환불 보증: 14 days

2년 보증

당사 고객을 위한 무료 온라인 기술 지원

전문 Adblue 에뮬레이터, 설명서 포함

최고급 자동차용 부품으로 제조

장치 정보

제품 코드: ME-FH4-E6-W

제품 유형: Adblue 에뮬레이터

엔진 유형: VOLVO

호환 ECU: EMS

시리즈: 4 series, RETARDER MODELS

배출 표준: EURO 6

제조된 트럭 2014 - 2021

호환 모델: FH, FM, FMX

설치

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug)

Power connections:

BROWN wire from emulator connect to - PIN 58 (-Negative)

RED wire from emulator connect to- PIN 60 (+ Positive/power)

CAN LINE Connections:

CAN 1 - Cut wires PIN1 and PIN5 and connect the emulator to the wires going toward the truck, not to the ends that goes into the plug.

WHITE wire from emulator connect to PIN1

BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

GREEN wire from emulator connect to PIN10

YELLOW wire from emulator connect to PIN14

Step three:

Please disconnect NOx sensor. To do this please cut wire from PIN 49 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

관련 상품