Adblue emuliatorius, skirtas Volvo 4-Series FH4, FM4, FMX4 Euro 5

Adblue emuliatorius (retarderiui) Volvo 4-Series FH4, FM4, FMX4 Euro 5 vilkikams (2014-2021). Visiškas SCR ir NOx išjungimas.

1–3: €350 · 4–5: €295 · 6+: €270

  • Suderinami modeliai: Volvo 4-SERIES FH4, FM4, FMX4
  • Metų intervalas: 2014–2021
  • Emuliatoriaus tipas: Hard-wired
  • Prekės ženklas: Can Logic
  • Garantija: 2 years

Šis įrenginys pakeičia

  • SCR / ECU valdymo blokas
  • Adblue siurblio modulis
  • Slėgio jutiklis
  • Adblue lygio jutiklis
  • Temperatūros jutiklis
  • NOx prieš katalizatorių
  • NOx po katalizatoriaus

Aprašymas

Svoris: 0.66kg

Prekės ženklas: Can Logic

Emuliatoriaus tipas: Laidinis

Pinigų grąžinimo garantija: 14 days

2 metų garantija

Nemokama internetinė techninė pagalba klientams

Profesionalus Adblue emuliatorius, pridedama instrukcija

Pagaminta naudojant aukščiausios kokybės automobilių komponentus

Įrenginio informacija

Gaminio kodas: ME-FH4-E5-RW

Produkto tipas: Adblue emuliatorius

Variklio tipas: VOLVO

Suderinama ECU: EMS

VOLVO Serija: 4 series

Emisijų standartas: EURO5

Sunkvežimiams, pagamintiems 2014 - 2021

Suderinami modeliai: FH, FM, FMX

Įrengimas

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

BROWN wire from emulator connect to - PIN 58 (- Negative)

RED wire from emulator connect to- PIN 60 (+ Positive/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

WHITE wire from emulator connect to PIN1

BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

GREEN wire from emulator connect to PIN10

YELLOW wire from emulator connect to PIN14

Step three:

After installing the emulator you will need to remove power from

the NOx sensor.

Remove the plug from the NOx sensor.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

Susiję produktai