Adblue emuliatorius, skirtas Volvo FH4, FM4, FMX4 Euro 6

Adblue emuliatorius (retarderiui) Volvo FH4, FM4, FMX4 Euro 6 vilkikams (2014-2021). Visiškas SCR, NOx ir DPF išjungimas.

1–3: €320 · 4–5: €260 · 6+: €200

  • Suderinami modeliai: Volvo FH4, FM4, FMX4
  • Metų intervalas: 2014–2021
  • Emuliatoriaus tipas: Hard-wired
  • Prekės ženklas: Can Logic
  • Garantija: 2 years

Aprašymas

Svoris: 0.03kg

Prekės ženklas: Can Logic

Emuliatoriaus tipas: Laidinis

Pinigų grąžinimo garantija: 14 days

2 metų garantija

Nemokama internetinė techninė pagalba klientams

Profesionalus Adblue emuliatorius, pridedama instrukcija

Pagaminta naudojant aukščiausios kokybės automobilių komponentus

Įrenginio informacija

Gaminio kodas: ME-FH4-E6-W

Produkto tipas: Adblue emuliatorius

Variklio tipas: VOLVO

Suderinama ECU: EMS

Serija: 4 series, RETARDER MODELS

Emisijų standartas: EURO 6

Sunkvežimiams, pagamintiems 2014 - 2021

Suderinami modeliai: FH, FM, FMX

Įrengimas

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug)

Power connections:

BROWN wire from emulator connect to - PIN 58 (-Negative)

RED wire from emulator connect to- PIN 60 (+ Positive/power)

CAN LINE Connections:

CAN 1 - Cut wires PIN1 and PIN5 and connect the emulator to the wires going toward the truck, not to the ends that goes into the plug.

WHITE wire from emulator connect to PIN1

BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

GREEN wire from emulator connect to PIN10

YELLOW wire from emulator connect to PIN14

Step three:

Please disconnect NOx sensor. To do this please cut wire from PIN 49 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

Susiję produktai