Emulador de Adblue para Volvo FH5, FM5, FMX5 Euro 6

Adblue emulador (on/off) para Volvo FH5, FM5, FMX5 Euro 6 (2022-2024). Anulación total de SCR, NOx y DPF. Se instala en 10-15 minutos, sin programación.

1–3: €320 · 4–5: €260 · 6+: €200

  • Modelos compatibles: Volvo FH5, FM5, FMX5
  • Años de fabricación: 2022–2024
  • Tipo de emulador: On/Off Switch
  • Marca: Can Logic
  • Garantía: 2 years

Este dispositivo reemplaza

  • Unidad de control SCR / ECU
  • Sistema de escape DPF
  • Módulo de bomba Adblue
  • Sensor de presión
  • Sensor de nivel Adblue
  • Sensor de temperatura
  • NOx antes del catalizador
  • NOx después del catalizador

Descripción

Peso: 0.03kg

Marca: Can Logic

Tipo de emulador: On/Off Switch

Garantía de devolución: 14 days

2 años de garantía

Soporte técnico en línea gratuito para nuestros clientes

Emulador Adblue profesional, instrucciones incluidas

Fabricado con componentes de calidad automotriz superior

Información del dispositivo

Código de producto: ME-FH5-E6-ON

Tipo de producto: Emulador Adblue

Tipo de motor: VOLVO

ECU compatible: EMS

VOLVO Serie: 5 series

Norma de emisiones: EURO 6

Para camiones fabricados 2022 - 2025

Modelos compatibles: All Trucks

Instalación

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Productos relacionados