Adblue Emulator for Volvo FH5, FM5, FMX5 Euro 6

Adblue emulator (on/off) for Volvo FH5, FM5, FMX5 Euro 6 (2022-2024). Full SCR, NOx & DPF delete. Fits in 10-15 minutes, no programming.

1–3: £270 · 4–5: £220 · 6+: £170

  • Compatible models: Volvo FH5, FM5, FMX5
  • Year range: 2022–2024
  • Emulator type: On/Off Switch
  • Brand: Can Logic
  • Warranty: 2 years

This device replaces

  • SCR / ECU control unit
  • DPF exhaust system
  • Adblue pump module
  • Pressure sensor
  • Adblue level sensor
  • Temperature sensor
  • NOx before catalyst
  • NOx after catalyst

Description

Weight: 0.03kg

Brand: Can Logic

Emulator type: On/Off Switch

Money Back Guarantee: 14 days

2 Year warranty

Free technical support online for our customers

Professional Adblue emulator, instructions supplied

Manufactured using highest quality automotive grade components

Device information

Product code: ME-FH5-E6-ON

Product type: Adblue Emulator

Engine type: VOLVO

Compatible ECU: EMS

VOLVO Series: 5 series

Emissions standard: EURO 6

For trucks manufactured 2022 - 2025

Compatible Models: All Trucks

Installation

Step one:

Emulator is to be connected to the ACM plug. Please find ACM module (this is located right hand side of the frame) Remove/unplug ACM plug.

Step two:

Please connect emulator as shown below. (connect to wires from ACM plug) Power connections:

- BROWN wire from emulator connect to PIN 58 (- Negative)

- RED wire from emulator connect to PIN 60 (+ Positive/power)

- Cut PIN3 wire and connect the GREY wire from the emulator to the wire going into the plugt, not to the end that goes oward the truck. (+ Ignition/power)

CAN LINE Connections:

CAN 1 - DO NOT cut these wires, Connect the wires in parallel.

- WHITE wire from emulator connect to PIN1

- BLUE wire from emulator connect to PIN5

CAN 2 - DO NOT cut these wires, Connect the wires in parallel.

- GREEN wire from emulator connect to PIN10

- YELLOW wire from emulator connect to PIN14

Step three:

Please disconncect ACM ECU

To do this please cut wire from PIN 3 and isolate the ends.

Step four:

Once emulator has been installed turn ignition on and check Adblue level gauge is showing, this would indicate installation has been successful.

LED Light indicators:

- Ignition OFF - No LED

- Ignition ON (Emulator) - RED LED, BLUE blinking

- Ignition ON (Original SCR) - GREEN LED, BLUE blinking

ON/OFF switch function instructions:

1. Turn ignition ON (do not start the engine).

2. Press the accelerator pedal fully down and hold it pressed for 10 seconds.

3. Release the accelerator pedal and turn ignition OFF. Wait for 10 seconds.

4. Start the engine.

If done correctly, the system should switch to the desired mode.

Related products